Researchers Develop Effective Thermal Energy Storage System

Panneer Selvam, center, Micah Hale, left, and Matt Strasser display the thermocline energy storage test system outside the Engineering Research Center in south Fayetteville.
Photo Submitted

Panneer Selvam, center, Micah Hale, left, and Matt Strasser display the thermocline energy storage test system outside the Engineering Research Center in south Fayetteville.

FAYETTEVILLE, Ark. – Engineering researchers at the University of Arkansas have developed a thermal energy storage system that will work as a viable alternative to current methods used for storing energy collected from solar panels. Incorporating the researchers’ design into the operation of a concentrated solar power plant will dramatically increase annual energy production while significantly decreasing production costs.

Current storage methods use molten salts, oils or beds of packed rock as media to conduct heat inside thermal energy storage tanks. Although these methods do not lose much of the energy collected by the panels, they are either expensive or cause damage to tanks. Specifically, the use of a packed rock, currently the most efficient and least expensive method, leads to thermal “ratcheting,” which is the stress caused to tank walls because of the expansion and contraction of storage tanks due to thermal cycling.

 “The most efficient, conventional method of storing energy from solar collectors satisfies the U.S. Department of Energy’s goal for system efficiency,” said Panneer Selvam, professor of civil engineering. “But there are problems associated with this method. Filler material used in the conventional method stresses and degrades the walls of storage tanks. This creates inefficiencies that aren’t calculated and, more importantly, could lead to catastrophic rupture of a tank.”

As an alternative to conventional methods, Selvam and doctoral student Matt Strasser designed and tested a structured thermocline system that uses parallel concrete plates instead of packed rock inside a single storage tank. Thermocline systems are units – bodies of water, such as oceans and lakes, for example, but also smaller units that contain fluids or gas – with distinct boundaries separating layers that have different temperatures. The plates were made from a special mixture of concrete developed by Micah Hale, associate professor of civil engineering. The mixture has survived temperatures of up to 600 degrees Celsius, or 1,112 degrees Fahrenheit. The storage process takes heat, collected in solar panels, and then transfers the heat through steel pipes into the concrete, which absorbs the heat and stores it until it can be transferred to a generator.

Modeling results showed the concrete plates conducted heat with an efficiency of 93.9 percent, which is higher than the Department of Energy’s goal and only slightly less than the efficiency of the packed-bed method. Tests also confirmed that the concrete layers conducted heat without causing damage to materials used for storage. In addition, energy storage using the concrete method cost only $0.78 per kilowatt-hour, far below the Department of Energy’s goal of achieving thermal energy storage at a cost of $15 per kilowatt-hour.

 “Our work demonstrates that concrete is comparable to the packed-bed thermocline system in terms of energy efficiency,” Selvam said. “But the real benefit of the concrete layers is that they do not cost a lot to produce compared to other media, and they have the unique ability to conduct and store heat without damaging tanks. This factor alone will increase production and decrease operating expenses for concentrated solar power plants.”

In 2008, Selvam, holder of the James T. Womble Professor of Computational Mechanics and Nanotechnology Modeling, received a $770,000 award from the U.S. Department of Energy to develop a novel method of storing thermal energy in concrete. The award and research project were part of the federal government’s initiative to develop technology for low-cost energy storage of solar power.

Selvam also directs the university’s Computational Mechanics Laboratory.

Strasser is a Doctoral Academy Fellow. The Doctoral Academy Fellowships were created in 2002 as part of a $100 million endowment established by a $300 million gift from the Walton Charitable Support Foundation.

Contacts

Panneer Selvam, professor, civil engineering
College of Engineering
479-575-5356, rps@uark.edu

Matt McGowan, science and research communications officer
University Relations
479-575-4246, dmcgowa@uark.edu

Headlines

The World as a Classroom: The Executive M.B.A. Program at U of A

The program, offered through the Sam M. Walton College of Business, blends online learning with face-to-face interaction and applied studies in a real-time international immersion trip.

Keri Blakinger, Author of 'Corrections in Ink,' to Speak at Fayetteville Public Library April 22

Blakinger, an award-winning journalist now at the Los Angeles Times, will talk about her memoir and her work as a reporter at 6 p.m. April 22 at the Fayetteville Public Library's Walker Community Room.

Visit With University Libraries and Pat Walker Health Center's Medical Services at Carnival Today

Employees are invited to meet fellow workers from units across campus including the University Libraries and the Pat Walker Health Center at today's Making Your Day Work Carnival at the Arkansas Union.

Farewell Reception April 3 for Fulbright College's Lisa Summerford

The campus community is invited to celebrate Summerford's achievements and to wish her well during a drop-in retirement reception from 3:30-5 p.m. Wednesday, April 3, in the Fulbright College Dean's Office in Old Main 523.

Rachel McGathy Retiring After 25 Years

There will be a reception to celebrate McGathy's retirement from 2:30-4:30 p.m. Friday, March 29, in the downstairs breakroom at Uptown East.

News Daily